ECM TITANIUM – Drivers
In addition to the standard maps useful to significantly increase the performance of these ECUs, we present some specific maps, which will lead you to even better results.
MED17.5.21
AUDI
SEAT
SKODA
VOLKSWAGEN
MED17.5.25
AUDI
SEAT
SKODA
VOLKSWAGEN
The special functions that can be modified using the new updated drivers for MED17.5.21 and MED17.5.25 are the following:
Thanks to the introduction of fuel cut management maps, it is possible to delay the intervention of this function to obtain the effect of the explosions (pops and bangs) when the accelerator is released.
In addition to delaying the fuel cut, it is necessary to intervene on the advance maps in order to obtain the best possible effect, for this reason all the necessary maps of this category are now available in the drivers:
To the standard maps that allow you to increase the rev limiter, the possibility of working on the rev limiter for non-moving vehicles (when the vehicle is not moving) has also been introduced, which is set at a very low value for anti-pollution regulations, this map also works on vehicles with automatic gearbox (the limiter in this case is active when the gearbox is in position D or N)
These maps allow the installation of a direct exhaust system (without catalyst), preventing the appearance of DTCs and warning lights / engine failure.
In the next few weeks, Drivers update on Bosch EDC17CP54. Any examples?
Read and write ECUs installed on Buick, Cadillac, Chevrolet, GMC, Pontiac and Saturn brand vehicles thanks to the new protocol for KESS3.
Four new protocols enlarge the KESS3 vehicle list, working with a single tool in simple and safe ways on diesel engines installed on Alfa Romeo, Fiat, Lancia, Mazda and Toyota brands.
Two new motorbike protocols are available for KESS3: work on new ECUs with different connection modes using just one tool.
Thanks to two new protocols dedicated to the heavy-duty market, you will be able to operate on a large vehicle base and meet the customer’s needs.
With KESS3 you can now read, write and clone Ka+ ECU from 2018.
Enhance performance and driving pleasure safely by recalibrating a lot of automatic transmissions installed in Audi, Mercedes-Benz and Volkswagen without opening the TCU.
