ECM TITANIUM – Drivers
In addition to the standard maps useful to significantly increase the performance of these ECUs, we present some specific maps, which will lead you to even better results.
MED17.5.21
AUDI
SEAT
SKODA
VOLKSWAGEN
MED17.5.25
AUDI
SEAT
SKODA
VOLKSWAGEN
The special functions that can be modified using the new updated drivers for MED17.5.21 and MED17.5.25 are the following:
Thanks to the introduction of fuel cut management maps, it is possible to delay the intervention of this function to obtain the effect of the explosions (pops and bangs) when the accelerator is released.
In addition to delaying the fuel cut, it is necessary to intervene on the advance maps in order to obtain the best possible effect, for this reason all the necessary maps of this category are now available in the drivers:
To the standard maps that allow you to increase the rev limiter, the possibility of working on the rev limiter for non-moving vehicles (when the vehicle is not moving) has also been introduced, which is set at a very low value for anti-pollution regulations, this map also works on vehicles with automatic gearbox (the limiter in this case is active when the gearbox is in position D or N)
These maps allow the installation of a direct exhaust system (without catalyst), preventing the appearance of DTCs and warning lights / engine failure.
In the next few weeks, Drivers update on Bosch EDC17CP54. Any examples?
With this new protocol dedicated to the agri-world, you can work in total reliability thanks to the BENCH mode of KESS3.
Even more possibilities for modification and customisation are available for Audi, Seat, Skoda and Volkswagen.
Work with maximum speed and efficiency for the complete satisfaction of your customers.
Three new protocols expand the list of vehicles supported by KESS3: work with a single tool to satisfy your customers on the latest generation Delphi control units.
Increase the performance and driving pleasure at the maximum speed thanks to the dedicated recalibration for some automatic transmissions installed on Audi and Volkswagen.
Work to tune and repair on the Bosch DCU17PC43 unit with the new BENCH mode protocol for KESS3.
