Read and write in OBD the Keihin and Continental ECUs installed on KTM and Husqvarna cross/enduro bikes.
We’ve developed two new protocols for your workshop to cater to off-road enthusiasts.
K-SUITE – RELEASE 3.96
Thanks to this update, you will be able to perform all the operations necessary for the calibration and the repairing on dozens of work vehicles like IVECO, CASE IH, NEW HOLLAND and FENDT equipped with the ECU Bosch EDC7.
Today the released protocol allows you to connect to the ECU through the connectors: there will be no need to open the ECU, an operation that is always quite delicate, especially on this kind of ECU.
The EDC7 is the most widespread ECU on the work vehicles.
Buses, tractors, earthmovers, and small industrial vehicles are equipped worldwide with this ECU.
New K-TAG Protocol
We’ve developed two new protocols for your workshop to cater to off-road enthusiasts.
Three new protocols have expanded KESS3’s vehicle list, allowing you to work on newly supported vehicles from Isuzu, Mazda and Toyota.
Work with two new protocols dedicated to motorcycles to meet your customer’s needs quickly and effectively.
Work reliably and effectively on the transmission control units (TCUs) that are equipped on numerous Buick, Cadillac, GMC and Chevrolet vehicles.
Even more possibilities for modification and customisation are available for Yamaha motorbikes.
We’re diving into tuning and cloning using two new protocols, all through KESS3’s BENCH mode.